Listed in "Best Airgun Cleaning Pull-Through" the Vector Air Kevlar Pull-Thorugh Kit is entirely made in-house using Kevlar Line for a full-strength pull-through cleaning set. 

The Kevlar Pull Through set has become a popular go-to for removing leading or cleaning your barrel. It is sometimes a good measure to clean your barrel if the gun is new to remove oils from manufacturing.

Unlike powder burners, you do not need to clean your barrel after every shoot. Airguns need to be leaded by shooting 500-1000 shots through before the lead starts to tighten up the barrels bore onto the pellet.

If you have leaded your barrel (500-1000 shots) and have started to notice a spread issue, this is when you are most likely going to need to de-lead your barrel with the pull-through and start the leading process again.

To Clean or De-Lead follow the steps below:

• Spray barrel cleaning oil (VA40) into the barrel then simply feed the line through the front of the barrel until the Kevlar loop appears at the breach.
• Load 1-5 patches (depending on calibre and severity of barrel leading) lightly sprayed with barrel cleaning oil before pulling the line through the barrel (ensuring not to remove the breach seals).
• Repeat with patches until they come through clean. Ensure to swap patches when they become over soiled

Includes:

• 800mm Kevlar threaded pull thorough line
• approx 25 cleaning patches.